WORK SESSION B - May 30, 2013 - PART I

Discussion Pertaining to Work Session B - 2013

WORK SESSION B - May 30, 2013 - PART I

Unread postby Ted Smith » Thu May 30, 2013 7:14 pm

Much activity still very evident in both Chama and Antonito as Work Session B is winding down! Tomorrow is the last day of this work session, and volunteers are to be commended on excellent progress, as shown in the following photos:
037.JPG
Dan Sandt and George Trever work on installing hand rail on the "Cinder Bear" rider gondola!
038.JPG
Marshall Smith and George Davies, in the Nut and Bolt Car, get more bolts for the rider gondola project.
040.JPG
Seat brackets are being installed on the side of the rider gondola.
049.JPG
Ted Kazmar installs more seat brackets; George Davies is in the far end of the rider gon.
039.JPG
TL Spero Bettalico and Carol Mackey are inside the current tool car. The new tool car should be finished in a later 2013 work session.
045.JPG
Dona Kazmar weeds the edge of the Chama garden area.
046.JPG
Yet another new set of steps into a reefer has been built by Carpentry Shop TL Len Jones; the new ones are much safer than the ones being replaced.
51.JPG
Fred Pitroff puts primer on the blocks that will hold the clerestory screens in place; Cook Car #053 was rebuilt in the late 1980's and the screens were all rebuilt. Except for being dirty, they are in excellent condition and will be cleaned up, painted and reinstalled during a later work session.
59.JPG
Photo of the underside of the new tongue and groove roof of the restored Cook Car. It will be painted during a later 2013 work session.
60.JPG
TL Craig McMullen installs an inside "grab iron" in the Cook Car. Originally, there was a door at this location for grabbing mail sacks when the car was an RPO.
Ted Smith
Head Brakeman
Head Brakeman
 
Posts: 99
Joined: Mon Nov 28, 2011 11:46 pm

Return to Work Session B (May 27 - May 31)

Who is online

Users browsing this forum: No registered users and 5 guests