9/27/18 Thursday

[Sharon Evans]

Looks like the chroniclers at work with Sharon McGee on the far side

Consulting the plans for a project

The rest of the photographs from today cover the installation of the wheel set into their frame. I have done my best to describe what is going on, so any additional input would be welcome.

Fitting a wheel set into the truck frame

View from the other side

Easing the frame down onto the wheel set

First one done, now for the other wheel set

...and here it comes. Amazing how easy they roll when on the track

Getting things ready to lift the frame

The lift is pushed into place

Hooked up and ready to lift

[Sharon Evans]

Lubricating the axle on the wheel

Now the axle framing and bushings are on

moving the wheel forward to they can lower the fame onto the frame

Tilting the bushing slightly so it lines up to the frame

Slowly is the name of this game

The folks in Antonito have downloaded more photos from today which I will process and post tomorrow.



.

[Tom Casper]

You do very good with your descriptions. Here is a little more info on this one. "Tilting the bushing slightly so it lines up to the frame"
That is the Axle Box that holds the brass bearing, along with oil and waste material to distribute the oil.

Tom C.

[Craig Kumler]

Are there any cars in the CRF currently being worked on?

[Sharon Evans]

Are there any cars in the CRF currently being worked on?

.


When I process the rest of yesterday's photos Craig, you will see a Gramps tanks car currently being worked on.

[Sharon Evans]

Pictures from today continued: There is a lot more

Well, Doc McMullen is doing the cooking for hamburger day

Cooking those burgers is hard work, but someone has to step up

Consulting the plans for a car being reconstructed

More work with the plans

Machining some stock for a needed part

Nailing boards onto a stock car 5774 under refurbishment

More work nailing new boards onto the stock car 5774

Working on the flat car 6200 as we see the stock car behind

.

[Sharon Evans]

A lot of time went into installing a new coupler onto the Gramps tank car 11050 and here is a selection of the photos taken.

A powered lift is being used to get the coupler placed on the Gramps car

Working on getting the coupler to proper alignment

A better view as the coupler is eased into its housing by the power lift

The coupler in its pocket is now being eased under the car

Installing the coupler on one end of the Gramps car

Easing the coupler in its housing up into the frame on the car

Bolting the housing into the car

The coupler has now been placed into its pocket

The Gramps tank car has one of the trucks shoved into place

Crew moving one of the trucks under the Gramps tank car

.

[Sharon Evans]

Chama doings:

The crew standing in front of the RGS car

Cleaning up inside this RGS MoW car

The car inside with opening in the floor

Looking the other way in the car

Looks like some bench seats are about to be installed into the car

.

[Sharon Evans]

A few more from Antonito: Be sure to click on an image to see it full size.

2018-09-27 Working on another great lunch for the working folk.jpg (147.83 KiB) Viewed 2663 times

2018-09-27 Using a front end loader to position a new beam on stock car 5774.jpg (187.08 KiB) Viewed 2663 times

2018-09-27 Close up of getting that beam into the correct spot.jpg (117.25 KiB) Viewed 2663 times

2018-09-27 One of the Friends is working on flat car 6200.jpg (135 KiB) Viewed 2663 times

.